The installation of an outboard bearing of this design allows you to straighten the driveshaft, which removes a significant part of the vibrations during movement. Straightening the drive shaft unloads the output shaft of the transmission, the input shaft of the front gearbox, as well as the bearings of these units. All this prolongs their service life. The 2-part outboard bearing design makes it possible to install the driveshaft in the most free position and greatly facilitates installation. The bearing used in our design is maintenance-free - it is of a closed type, filled with grease and completely protected from contamination. But even in case of wear on long runs, it can be replaced with a similar one, since our product uses a serial bearing from a reliable and well-established supplier.
Retrofitting with our outboard bearing is recommended not only in case of failure of the original one, but also for new equipment. This will allow you to make operation more pleasant for you and easier for the equipment from the very first kilometers of the run.
